Skip to content
Driveways, walkways and patios

Concrete Garage Floors in North Phoenix, AZ

Concrete Floors

Garage and shop floors that hold up.

Interior floors live by different rules than outdoor flatwork. They need to be flat, carry point loads like a jack stand or a lift, and stand up to whatever drips off the car. We handle tear-out, base, vapor barrier, joints and a finish that suits the room, from smooth trowel to epoxy.

Typical price$10–$16 / sq ft replacedinstalled · free written estimate
(602) 773-1313
Smooth-trowel finishJoints cut same daySlopes to the drainBuilt for truck loadsVapor barrierCompacted base
How we build a floor
Real work

Floors by Sam The Concrete Man

Photos from Sam The Concrete Man jobs. Each caption says whose job it was.

Freshly poured garage floor seen through the open garage door
Sam The Concrete Man
New concrete floor inside a garage, seen from a corner
Sam The Concrete Man, another location
Polyaspartic flake coating on a covered slab
Sam The Concrete Man, another location
Interior floor acid-stained in amber and green with a glossy finish
Sam The Concrete Man
See more in the gallery →
What we build

Concrete Floors, start to finish

  • Garage floor replacement
  • Shop and outbuilding floors
  • Slabs for garage and room additions
  • Smooth-trowel and sealed finishes
  • Epoxy and flake coatings
  • Floor drains and slope to the door
Key considerations

What goes into it

  1. 01A vapor barrier where it belongs
  2. 02Thickness for vehicle and equipment loads
  3. 03Joints cut the same day
  4. 04Slope toward the door or drain
  5. 05A sealer or coating against oil and stains

Good concrete starts long before the truck arrives. Our experienced team knows what to look for, what questions to ask, and which details can make the difference years down the road.

Built for the Valley

What Phoenix asks of a floor

A hot-weather pour, indoors too

A garage slab poured in summer is still a hot-weather pour. Industry practice limits fresh concrete to 95°F at delivery unless a hotter mix is proven, so the pour is scheduled and the mix adjusted for the day.

Coatings need prep

Epoxy and flake coatings resist oil and stains and clean with a mop, but they need a clean, sound, prepared slab to bond to. That prep is most of the job, and it is why a coating goes on after the new slab has cured.

What's under the surface

A slab sized for what sits on it

Not to scale · sized to each job
12345Hot tub, RV, shed or equipmentNative soil
1Point loads: a filled hot tub can weigh as much as a car, all on a few square feet.
2Compacted base sized for the load, so the slab is supported evenly from edge to edge.
3A vapor barrier under interior floors keeps ground moisture out of the room above.
4A rebar grid on chairs, with thickened edges where the load reaches the perimeter.
5Joints cut the same day, before shrinkage can pick its own crack line.
How it runs

Estimate to final walkthrough

  1. 1On-site estimate and load review
  2. 2Written quote with a clear price
  3. 3Tear-out, base and vapor barrier
  4. 4Pour, trowel, cut joints and walkthrough
Finish options

Straightforward or decorative

Broom finish

Fine ridges for grip when it’s wet from a storm or the sprinklers. The standard for driveways and walks.

Integral color

Color mixed through the concrete, so chips don’t show grey and the sun doesn’t fade it.

Smooth trowel

Dense and flat for garage floors, shops and courts.

Sealed

A UV-resistant sealer against water, stains and sun fade, renewed every few years.

Every finish, with photos →
Where you live changes the job

A floor on caliche is a different job than one on wash sand

The Valley has four kinds of ground, and each one changes how we prepare the base, reinforce the slab and handle water. Your community page has the specifics.

Caliche desert floor

Dig to firm ground, break out caliche that sits high in the base and haul it off the site, bring in aggregate base compacted in lifts, and slope the slab and the grade so roof and sprinkler water run away from it and off the hardpan.

River and wash alluvium

Compaction done in lifts at the right moisture, with loose or soft soil dug out and replaced, a thicker section anywhere a truck, trailer or RV will park, and grading that keeps runoff off the slab and out from under it. Washes and drainage easements stay open.

Expansive clay pockets

Remove the soft and organic soil, bring in compacted aggregate base, set rebar on chairs, and keep the moisture under the slab steady: drainage away from it, and turf and drip lines held back from its edges.

Desert foothills and rock

Excavation into the rock or hardpan, a thicker compacted base where the support is uneven, drainage that catches runoff above the slab and carries it around, and engineered retaining walls where the grade is cut. Walls on hillside lots often need a permit, and each city and town has its own rules, so we check yours.

Questions about floors

Concrete Floors: what people ask us

Replacing a garage floor usually runs $10–$16 per square foot, including breaking out and hauling away the old slab. A two-car garage typically lands between $4,000 and $9,000, depending on its size, access, thickness and whether a drain or vapor barrier goes in.

Typical prices for every kind of project are in the Phoenix concrete cost guide, and general questions are on the FAQ page.

Get a clear price on your floor.

You'll know, without question, what your project involves, what it costs, and what to expect before work begins.

(602) 773-1313